Food Establishment Inspection Report |
||||||||||||||||||||||||||||
Page 1 of ????????? | ||||||||||||||||||||||||||||
|
|
FOODBORNE ILLNESS RISK FACTORS AND PUBLIC HEALTH INTERVENTIONS |
Circle designated compliance status (IN, OUT, N/O, N/A) for each numbered item IN=in compliance OUT=not in compliance N/O=not observed N/A=not applicable Mark "X" in appropriate box for COS and/or R COS=corrected on-site during inspection R=repeat violation |
Risk factors are important practices or procedures identified as the most prevalent contributing factors of foodborne illness or injury. Public health interventions are control measures to prevent foodborne illness or injury. |
|
|
GOOD RETAIL PRACTICES |
Good Retail Practices are preventative measures to control the addition of pathogens, chemicals, and physical objects into foods. Mark "X" in the box if the numbered item is not in compliance Mark "X" in appropriate box for COS and/or R COS=corrected on site during inspectionR=repeat violation |
|
|
Food Establishment Inspection Report |
||
Page 2 of ?????? | ||
Establishment: FIRST WATCH | License/Permit #: 010912 | Date: 05/08/2025 |
Water Supply: Community Non-Community Licensed Non-Community Waste Water System: Community On-Site IEPA System |
Sanitizer: | Temperature Logs in Use: |
Location | Method | Sanitizer Type | Concentration (PPM) | Heat(F) |
LT Dish Machine | Chemical Sanitizer | Chlorine | 50 | 0.00 |
Spray Bottle | Chemical Sanitizer | Quaternary Ammonium | 300 | 0.00 |
CFPM Verification (name, expiration date, ID#): | |||
ADAM HOSTENEY 08/03/2028 24327823 |
|||
Presentation Type: | VISUAL | Number Attended: | 1 |
HACCP Discussed | HACCP Principle | Plan Onsite |
1. Determine the Hazard | Discussed the HACCP principle of identifying critical control points such as hot holding at 135 degrees F or above and cold holding at 41 degrees F or below. | No |
IL Requirements: | Use of non-latex gloves for food handling and preparation 410 ILCS 180/10. |
Appropriate default beverage for children's meal 410 ILCS 620/21.5. |
TEMPERATURE OBSERVATIONS |
Item/Location |
Temp |
Item/Location |
Temp |
Item/Location |
Temp |
CUT FRESH TOMATOES/COOK'S LINE COOLER | 41.00°F | CHEESE/COOK'S LINE COOLER | 37.00°F | CUT FRESH TOMATOES/COOK'S LINE COOLER | 37.00°F |
SAUSAGE/COOK'S LINE COOLER | 41.00°F | HAM/COOK'S LINE COOLER | 38.00°F | GRAVY/WALK-IN COOLER | 40.00°F |
CHICKEN/WALK-IN COOLER | 37.00°F | TURKEY/WALK-IN FREEZER | 0.00°F | SOUP/WALK-IN FREEZER | 0.00°F |
HOLLANDAISE/STEAM TABLE | 193.00°F | SAUSAGE/STEAM TABLE | 174.00°F | BEANS/STEAM TABLE | 153.00°F |
POTATOES /COOKING | 197.00°F |
OBSERVATIONS AND CORRECTIVE ACTIONS |
P=Priority PF=Priority Foundation C=Core R=Repeat |
Item Number |
P/PF/C/R | Code Reference | Violations cited in this report must be corrected within the time frames below. |
36 | C | 4-204.112 (A) |
(A) In a mechanically refrigerated or hot FOOD storage unit, the sensor of a TEMPERATURE MEASURING DEVICE shall be located to measure the air temperature or a simulated product temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot FOOD storage unit. A thermometer is not provided in the coolers with a digital reading. Provide thermometers in all coolers. CORRECT BY NEXT ROUTINE INSPECTION |
38 | C, R | 6-501.111 (A) (B) (D) |
The PREMISES shall be maintained free of insects, rodents, and other pests. The presence of insects, rodents, and other pests shall be controlled to eliminate their presence on the PREMISES by: (A) Routinely inspecting incoming shipments of FOOD and supplies; (B) Routinely inspecting the PREMISES for evidence of pests; (D) Eliminating harborage conditions. Fruit flies are present in kitchen. Contact licensed pest control to eliminate flies. Eliminate pests, using proper pest control processes as needed. Repeat,CORRECT BY NEXT ROUTINE INSPECTION |
ADAM HOSTENEY Person In Charge (Signature) |
Jessica Shurman Inspector |
Follow-up: Yes No | Follow-up Date: |